Rock Light Installations

ALL PLUG & PLAY ROCK LIGHTS INSTALLATION GUIDE PRE INSTALL:

Before getting started, You’ll want to have a plan of where you will be installing each rock light.

STEP #1: Installing The Bluetooth Control Module *VERY IMPORTANT*

Keep the module tucked up on the inner side of the frame, below the cab, and away from engine heat. This will give the module a central location and reduce the need to extend the 15 foot wire leads.

You may use zip-ties to secure the control box to the desired location.

***We recommend wiring the control module to a switch to avoid the constant flow of power through the module***

STEP #2: Installing The Rock Lights In Your Wheel Well

You’ll want to remove the plastic liners if you have them.

Place your rock light in the desired location and pre-drill holes that align with the rock light mounting locations.

Drill a third wider hole for the wire lead to fit through.

Use provided mounting hardware to secure the rock light & feed the wire lead through the third hole. Underbody & Misc

If you have purchased our magnetic mounts, your install just got a whole lot easier! Simply install our magnetic mounts on the pods and place them in your desired location! If you don’t have our magnetic mounts you may need to use self tapping screws and or adhesive to mount the pods.

STEP #3: Securing The Wire leads

Run the wire leads along the vehicles existing wiring keeping them tucked away and as high as possible. Using zip ties, secure the wires tightly so they cannot be easily pulled out of place.

Plug the wire lead into the corresponding Control Module hookup, ensuring your female and male end arrows are aligned.

STEP #4: Supplying Power & Ground

Due to the fact the module is mounted underneath your vehicle, you will need to simply extend the power and ground leads off of the module. For the power source you may directly use your battery, however a switch is required to control the power flow through the module. (Simple on/off switch)

If you have up-fitter switches, this will be your simplest power source option. (Power source is simply customer preference as long as its 12v)

STEP #5: Bluetooth Remote/App

Wen highly recommended connecting the app first via Bluetooth (LEDSHOW).

Download the app from your app store and make sure your phone's bluetooth is on without any paired devices.

Make sure your control module is efficiently supplied with a 12v power source and the fuse is in proper condition.

Your device will automatically pair to the module, and then you can control everything.